Shen Mintao
459a5dee6c
Route raw frames through the USB/SDIO confirmation rings, as reported by ggorbi99-dev in issue #123. Keep monitor support opt-in and document the limits of firmware and rate validation.
1.6 KiB
Monitor TX confirmation regression
Run python3 tests/monitor/test_tx_confirm.py. The fixture compiles the actual
USB and SDIO descriptor-selection blocks from rwnx_tx_push() with mocked
transport functions. It checks raw frames, normal management frames, EAPOL,
USB-specific WAPI handling, ordinary/fixed-rate data, ring registration before
transport submission, and accounting deferred until confirmation. It does not
send frames or model firmware, USB completion, or radio behavior.
To compare another revision, pass --source /path/to/rwnx_tx.c.
Build the optional monitor path with prepared kernel headers:
bash tests/kernel-build/build.sh /path/to/kernel/build CC=gcc-14 CONFIG_RWNX_MON_DATA=y
CONFIG_RWNX_MON_XMIT already defaults to y; CONFIG_RWNX_MON_DATA remains
opt-in. For hardware verification, re-open the monitor interface before setting
its channel and use a second radio on the same channel to capture a short
beacon/probe-request test on equipment you control. Check both 2.4 and 5 GHz,
normal station traffic after the test, and interface teardown/recreation.
The confirmation descriptor carries a ring index instead of the fixed-rate encoding. Radiotap-selected rates are not established by this check. Other chips, SDIO hardware and arbitrary raw data frames also require hardware validation.
Based on ggorbi99-dev's issue #123.
The contributor reports over-the-air validation on a D80 MCU1 USB adapter;
that report is not a hardware test of these commits or of the main firmware.