Legacy MCU revision 1 branch: You are viewing legacy-mcu1. This branch is only for AIC8800D80 devices that report chip_id=7, chip_mcu_id=1 and fail the current V5 FMAC upload at 0x170400. It uses the complete matched Radxa SDK V3 D80 firmware and loader profile validated in issue #58. Use main for newer chip_mcu_id=0 hardware or when the MCU revision is unknown. See the legacy MCU1 support notes before installing.

Added support for devices with Vendor ID 368B (tested).

Tested on Linux kernel 6.16 with Ubuntu 25.04 and 6.1.0.27 with Debian 12.

Bluetooth support: This branch initializes the integrated Bluetooth controller for the kernel's standard btusb driver. It does not contain or install aic_btusb.

Disclaimer

I did not develop this software, The code is sourced from the Tenda U11 driver. I only made some modifications to the code to adapt it to newer kernel versions. Apart from compilation issues, I am unable to address other problems.

Attention

Before installing the driver, delete all aic8800-related folders under /lib/firmware. Using an incorrect firmware version may cause the system to freeze.

Installation Steps

Method 1: Quick Installation (Recommended)

Method 2: Manual Installation

Copy udev rules:

Copy the aic.rules file to /lib/udev/rules.d/:

sudo cp aic.rules /lib/udev/rules.d/

Copy firmware:

Copy the aic8800D80 folder from ./fw to /lib/firmware/:

sudo cp -r ./fw/aic8800D80 /lib/firmware/

Navigate to the driver directory:

Change to the drivers/aic8800 directory:

cd ./drivers/aic8800

Compile and Install the Driver:

First, compile the driver:

make

Then, install the driver:

sudo make install

For any kernel updates, you'll need to reinstall the driver:

make clean
make
sudo make install

Load the Driver

After installation, load the driver with the following command:

sudo modprobe aic8800_fdrv

Verify the Module is Active

Check if the module is loaded correctly:

lsmod | grep aic

You should see output similar to:

aic8800_fdrv    536576  0
cfg80211        1146880 1   aic8800_fdrv
aic_load_fw     69632   1   aic8800_fdrv
usbcore         348160  10  xhci_hcd,ehci_pci,usbhid,usb_storage,ehci_hcd,xhci_pci,uas,aic_load_fw,uhci_hcd,aic8800_fdrv

After that, plug in your USB wireless network card.

Verify Wi-Fi Device is Active

To check if the Wi-Fi interface is recognized, run:

iwconfig

If the device is still not active, check the kernel logs for any errors related to the driver:

sudo dmesg